Tech-source Raptor DL-Lite Drivers for Linux Instrukcja Użytkownika Pobierz pdf (Strona 18)

Raptor DL-Lite Drivers for Linux Installation & Reference Manual

3-8

3.6.3 Screen Section

Identifier: Each screen must have a unique identifier

which will be used in the ServerLayout

section.

Device: This field specifies which device you want to

use for this screen. It should match the

Identifier specified in one of the Device

sections.

DefaultDepth: Should be set to either 8 or 24 depending

on the default visual desired. This is used

when 24-bit visuals will be used on the

screen, otherwise this field should be set to

Modes: This field should remain unchanged.

If multiple Raptor cards are installed, additional Screen

sections should be created. Each Screen section should

have a unique identifier. For more information please refer to

Section 4.5.

3.6.4 ServerLayout Section

This is the section which specifies the server layout for either

single-screen or multi-screen configuration.

This section is not modified automatically by the installation. It

must be modified for your specific configuration.

The following example shows the ServerLayout Section for a

single-screen configuration on the Raptor device.

Section "ServerLayout"

Identifier "XFree86 Configured"

NOTE: The ServerLayout section should already exist in

your XF86Config file. It must be modified manually to

include the Raptor card.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Brak uwag

Tech-source Raptor DL-Lite Drivers for Linux Instrukcja Użytkownika Strona 18